In the heating process, it is necessary to manually put the blank into the induction heating ring, and after heating, the heated blank needs to be taken out and put into the cavity of the forging equipment mold. The labor intensity is high, the production efficiency is low, and the lack of safety is insufficient. Because there is no flash, the utilization rate of the material is higher. It is possible to complete the finishing of complex forgings with one process or several processes. Because there is no flash, the force-bearing area of the forging is reduced, and the required load is also reduced. However, it should be noted that the blanks cannot be completely restricted. For this reason, the volume of the blanks should be strictly controlled, the relative position of the forging dies and the measurement of the forgings should be controlled, and efforts should be made to reduce the wear of the forging dies.